Toshiba tecra m2 4.18 RGB harness holder/RGB board/Modem jack

4.18 RGB harness holder/RGB board/Modem jack 4 Replacement Procedures
4.18 RGB harness holder/RGB board/Modem jack
Removing the RGB harness holder/RGB board/Modem jack
To remove the RGB harness holder/RGB board/modem jack, follow the steps below and
refer to figure 4-34 to 4-36.
1. Remove the following screw securing the RGB harness holder.
• M2.5×4B FLAT HEAD screw ×1
2. Take out the RGB harness holder while unhooking the front latches.
M2.5×4B FLAT HEAD
RGB harness holder
Figure 4-34 Removing the RGB harness holder
TECRA M2 Maintenance Manual (960-468) 4-53