Toshiba tecra m2 manual Hard Disk Test Tests and Diagnostics

3.11 Hard Disk Test 3 Tests and Diagnostics

4.The Hard Disk Test message will appear after you respond to the Detail Status prompt. Select the number of the subtest you want to execute and press Enter. The following message will appear during each subtest.

HARD	DISK TEST		XXXXXXX
SUB-TEST		: XX	ERROR COUNT		:XXXXX
PASS	COUNT : XXXXX
WRITE DATA : XX			READ DATA		:XX
ADDRESS		: XXXXXXSTATUS		:XXX

The first three digits of the ADDRESS indicate which cylinder is being tested, the fourth digit indicates the head and the last two digits indicate the sector.

The first digit of the STATUS number indicates the drive being tested and the last two digits indicate the error status code as explained in table 3-5 of the section 3.22.

Subtest 01 Sequential read

This subtest is a sequential reading of all the tracks on the HDD starting at track 0. When all the tracks on the HDD have been read, the test starts at the maximum track and reads the tracks on the HDD sequentially back to track 0.

Subtest 02 Address uniqueness

This subtest writes unique address data to each sector of the HDD track-by- track. The data written to each sector is then read and compared with the original data. There are three ways the HDD can be read:

•Forward sequential

•Reverse sequential

•Random

Subtest 03 Random address/data

This subtest writes random data to random addresses on the HDD cylinder, head and sector. This data is then read and compared to the original data.

TECRA M2 Maintenance Manual (960-468) 3-29