Toshiba tecra m2 - page 251

4.11 Cover/Touch pad 4 Replacement Procedures
Installing the Cover/Touch Pad
To install the cover/touch pad, follow the steps below and refer to figures 4-18 to 4-23.
1. Connect the touch pad cable to the connector on the touch pad.
2. Install the touch pad and touch pad switch on the cover while hooking the latches.
3. Turn the cover face down and secure the touch pad and touch pad switch to the cover
with the following screws.
• M2.5×4B FLAT HEAD screw ×2
4. Place the cover on the display assembly and secure the latches by pressing it. Secure
the cover with the following screw.
• M2.5×4B FLAT HEAD screw ×1
• M2.5×12B FLAT HEAD screw ×1
5. Connect the touch pad cable to the connector PJ3201 on the system board.
6. Close the display panel and turn the computer face down. Secure the cover with the
following screws to the display assembly.
• M2.5×4B FLAT HEAD screw ×1 (“4B” in the figure below)
• M2.5×6B FLAT HEAD screw ×7 (“6” in the figure below)
• M2.5×16B FLAT HEAD screw ×1 (“16” in the figure below)
• M2×4Z BIND screw ×1 (“4” in the figure below)
or
• M2×4 Stick screw ×1 (“4” in the figure below)
TECRA M2 Maintenance Manual (960-468) 4-37