Toshiba tecra m2 - page 281

4.23 Power switch board 4 Replacement Procedures
2. Remove the power switch board from the hole.
3. Disconnect the power switch cable from the connector PJ9610 on the power switch
board.
Power switch cable
PJ9610
Power switch board
Figure 4-47 Removing the power switch board
Installing the Power switch board
To install the power switch board, follow the steps below and refer to the figure 4-46 and 4-
47.
1. Connect the power switch cable to the connector PJ9610 on the power switch board.
2. Install the power switch board in place while passing through the hole.
3. Install the power button holder while hooking the two latches.
TECRA M2 Maintenance Manual (960-468) 4-67