Tyco manual F3200 output logic tokens affected by network MAF status, Nml

F3200 Installation & Programming Manual	Document No: LT0122
Network Programming

NETWORK MAF STATUS (CONTINUED)

5.System fault state.

True if any system fault is present. When true, this will cause any panel on the network which is programmed to use the MAF data from this panel, to energise the MAF fault relay and, (if the receiving panel is an F3200 panel), to turn its buzzer on when a new fault occurs.

6.Brigade test state.

True if a brigade test has been initiated (by holding down the brigade test key for 2 seconds) AND the local MAF alarm relay, (if any), is programmed to operate for a local brigade test. When true, this will cause any panel on the network which is programmed to use the MAF data from this panel, to energise the MAF alarm relay.

7.Silence alarms state.

True if the bells are isolated and the panel is programmed to send bells isolate as network silence. When true, this will cause any panel on the network which is programmed to use the MAF data from this panel AND is programmed to allow the receiving of network bells silence, to keep the bells off. For New Zealand operation this also includes the state of the silence alarms keyswitch.

NOTE 1.

In F3200 each zone may be individually mapped to MAF, BELLS, ANC1, and ANC2. However, the mapping of a zone to BELLS, ANC1 and ANC2 has NO effect on the MAF data transmitted on the network - it effects only the local relays on that panel. Mapping a zone to bells will cause the bells to turn on at the local panel of that zone but not at a remote panel. Mapping a zone to the MAF may cause the bells to turn on at a remote panel when the zone goes into alarm. Mapping a zone to ANC1/ANC2 will cause the respective ancillary relay to turn on at the local panel of that zone but not at a remote panel.

At any F3200 panel, the MAF status and totals it is currently receiving from any other panel may be viewed by recalling net panel status ( from the base display press [RECALL] [RECALL] [3] - refer also to the F3200 operator's manual ).

F3200 output logic tokens affected by network MAF status

The output logic tokens in an F3200 panel that are affected by the MAF status received from other panels are listed below. These tokens are not affected by MAF status from another panel unless that panel is programmed into the SID list of this panel and has "use MAF relay data" option enabled (refer section 11.4.3).

NML	This token is described in Section 7.4.3.2 and is affected by any network states
	which cause the Brigade Alarm or Brigade Fault relays to operate at this panel. This
	includes MAF alarm, MAF fault or system fault received from a SID that this panel is
	programmed to use the MAF status of.
BEL	False if the bells are locally isolated or if
	[common network bells silence is true AND this panel has "receive network bells
	SILENCE" enabled], otherwise true if
	1.	Local 5 second bells test occurring.
	2.	2 second ring for alarm on local zone in auto reset mode.
	3.	Alarm on any local non isolated zone mapped to bells
	4.	Common network maf alarm AND "receive network bells CONTROL"
		enabled.
	5.	Any entry in the FFCIF alarm queue and bells on for FFCIF alarm has been
		enabled with programming.
	Note:	For New Zealand operation, BEL will become true if the trial evac keyswitch is
		operated regardless of bells isolation or silence alarms.
Page 11-6		5 July 2001	Issue 2.7