Tyco F3200 manual Limited to six characters

Document No: LT0122	F3200 Installation & Programming Manual
	Programming

TEXT PROGRAMMING WITH A PC (CONTINUED)

The DELETE or BACKSPACE keys may be used to delete the last character typed, and the ESCAPE key may be used to abort the text entry for the selected item.

After the ENTER key is pressed the message "Saved OK" will appear if the text has been saved correctly into EEPROM.

To load a file of text names from the PC into the F3200 panel, the file should be set up as shown in the following example. The names may actually be in any order, and it is not necessary to have a name for every zone or relay, etc.

Ensure that the last name in the file is followed by a carriage return before the end of the file, i.e. put a blank line at the end of the file.

The characters S, Z, R, etc, must always be in column 1 and the text names must also start in column 1 (unless leading spaces are required, but this is unlikely).

S

40 character site name

(blank lines are allowed)

Z1

Example text name for zone 1 Z2

Name for zone 2 Z3

This name has leading spaces

Z4

This name does not have leading spaces

.

.

.

Z23

This name will be cut at 30 characters as it is too long Z24

Name for zone 24 R1

Name for module relay 1

.

.

.

R64

Name for module relay 64 A1

Name for ancillary 1 relay A2

Name for ancillary 2 relay
A3
Name for ancillary 3 relay
T1
Smoke
T4
Manual
T9
Therml	(limited to six characters)

Issue 2.7 5 July 2001 Page 6-21