1-5 sec The scanner waits the set amount of time after the transmission ends before resuming.

Note: The default setting is 2 sec.

Set Attenuator This setting controls the attenuator for search operation. Select your setting, then press the scroll control.

Off The attenuator is off.

On Reception is attenuated by about 18 dB.

Note: Turn on this setting if you are near other strong signal sources. Attenuation sometimes helps to reduce interference and desensitization that strong signals create.

Search with Scan This setting controls how search with scan works.

Set Lockout This setting controls whether the system is scanned when its quick key is enabled. Rotate the scroll control to select your setting, then press the scroll control.

Locked - the system is not scanned

Unlocked - the system is scanned

Note: You can also lock or unlock a system by pressing Func , selecting the system, then pressing Func + L/O.

Set Hold Time This setting controls how many seconds the scanner scans a system before moving to the next unlocked system.

Enter a value from 0-255, then press the scroll control to save the setting.

Notes:

If you select 0, the scanner stays on the system for a minimal time (only long enough to check cur- rent system activity).

The default setting is 2 seconds for each system.

Searching and Storing

96

Page 96
Image 96
Uniden BCD396T owner manual Searching and Storing