38
Appendix
Expand your telephone system
The handsets provided with your telephone sys tem are pre-registered. Each
handset is assigned a number that shows on the h andset display. Additional
handsets registered to the telephone system are as signed in sequential
order. For instance, if the telephone system already has HAN DSET 1 and
HANDSET 2, the new registered han dset is assigned HANDSET 3. This
telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
You can add new handsets (DS6201, purchased separately) to your
telephone system, but each handset must be regis tered with the telephone
base before use. When rst purchased, each expan sion handset shows
NOT REGISTERED. You may need to charge the handset before
registering to the telephone base. For more detail s on battery charging, see
the table on page 3.
To register a handset:
Place the unregistered handset in the telepho ne base or charger. If
PRESS FIND HS 4 SEC ON BASE does n ot appear on the handset
screen after a few seconds, remove the handset an d place it in the
telephone base or charger again.
On the telephone base, press and hold FI ND HANDSET for about four
seconds (until the red IN USE light on the tel ephone base turns on) and
then release the button. The handset s hows PLEASE WAIT... and it
takes about 10 seconds to complete the registratio n. The handset shows
HANDSET X REGISTE RED (X represents the handset number assigned)
and you hear a beep when the registration com pletes.
1.
2.
If the registration fails, the h andset shows NOT REGISTER ED. To reset the
handset, remove the handset fro m the telephone base and place it back i n.
Try the registration process aga in.
You cannot register a handset if any other system h andset is in use.
•
•