39
Appendix
Replace a handsetIf you want to replace a handset or re-assign th e designated handset number
of a registered handset, you must de-regis ter all the handsets and then
individually register each handset.
To make de-registration easier, read all of the instructions on this pag e before
you begin. To de-register all handsets:
Press and hold FIND HANDSE T on the telephone base for about 10
seconds (until the IN USE light on the tele phone base turns on and starts
to ash), then release FIND HANDSET.
Press and release FIND HANDS ET again. You must press
FIND HANDSET while the I N USE light is still ashing. The IN USE light
ashes for approximately seven seconds.
All system handsets show CONNECTI NG... The de-registration proce ss
takes about 10 seconds to complete. All handsets show
NOT REGISTERED when th e de-registration completes.
If de-registration fails, you might need to re set the telephone and try again.
To reset:
Pick up the registered handset and then pres s .
Press OFF/CLEAR and place the hand set back in the telephone base.
-OR-
Unplug the power from the telephone base, then plu g it back in.
1.
2.
3.
1.
2.
1.
You cannot de-register a handset if any sys tem handset is in use.