Installing the Network
Installing the Network
Important: Do not mix the two types of network layouts. Mixed configurations are not supported by Xantrex.
Important: Installing and replacing
Before You Begin the Installation
•Read the entire section before installing the network. It’s important to plan the installation from beginning to end.
•Assemble all the tools and materials required for the installation.
Installation Tools and Materials
Tools | The following tools may be required to install the Xanbus cables. |
| ❐ Phillips screwdriver, appropriately sized |
| ❐ Drill and 1/8" bit |
Materials | The following materials may be required to complete your installation. |
| ❐ CAT 5 or CAT 5e cables (available from Xantrex or computer supply stores) |
| ❐ Network connectors, if installing |
| ❐ # 6 screws, 2 per each network connector installed |
| ❐ Terminators |
Guidelines for Routing the Xanbus Cables
WARNING: Shock hazard
Do not route the Xanbus cables in the same conduit or panel as the AC and DC power cabling.
:
To ensure maximum performance of your network, follow these guidelines when routing the Xanbus cables.
•Route the cables away from sharp edges that might damage the insulation. Avoid sharp bends in the
•Allow at least 2 ¼ inches (57 mm) of space behind the wall to accommodate the depth of the unit and allow room for the cables to bend.
•Allow for some slack in the cable tension.
•Keep the alignment of wire pairs inside the sheath as straight as possible.
•Allow separation between data and power cables (data cables should only cross a power cable at right angles).
•Do not staple the cable with metal cable staples. Use appropriate hardware fasteners to avoid damage to the cable.
•Support horizontal cables using J hooks or cable trays.
