Xantrex Technology XW4024-120/240-60, XW4548-120/240-60, XW6048-120/240-60 manual

Inverter/Charger Installation

AC Wiring for a Triple-Inverter System

1.Prepare power distribution bars (supplied in 865-1020) by cutting away one of the four tabs, only three tabs per power distribution bar are required in a three inverter system. A total of 6 distribution bars should be prepared.

2.Mount the nine breakers on the din rail and install power distribution bars as follows:

a)Two distribution bars, L1 and L2 at the input (top) terminals of the INV1, INV2 and INV3 Grid breakers.

b)Two distribution bars, L1 and L2 at the input (top) terminals of the INV1, INV2 and INV3 Gen breakers.

c)Two distribution bars, L1 and L2 at the output (bottom) terminals of the INV1, INV2 and INV3 AC Load breakers.

3.Connect L1 and L2, AC wiring from each INV Grid breaker to the corresponding AC Input (AC1) terminal on each of the three inverters.

4.Connect L1 and L2, AC wiring from each INV Gen breaker to the corresponding AC Input (AC2) terminal on each of the three inverters.

5.Connect L1 and L2, AC wiring from each INV AC Load terminal from each of the three inverters, to the corresponding AC INV Out breaker terminal in the PDP.

6.Connect L1 and L2, AC Load wiring to the INV Out (AC Load) power distribution bar.

7.Connect L1 and L2, AC wiring from the Generator disconnect to the Gen breaker power distribution bars.

8.Connect L1 and L2, AC wiring from the Utility Grid distribution panel to the Grid breaker power distribution bars.

9.Connect neutral wiring from INV1 (supplied with PDP), INV2 (supplied in 865-1050) and INV3 (custom, see material list) to the neutral distribution bar in the PDP.

10.Connect ground wiring from INV1 (supplied with PDP), INV2 (supplied in 865-1050) and INV3 (supplied in 865-1050) to the ground distribution bar in the PDP.

Power Distribution bars in the XW Power Distribution Panel accept up to a #2/0 AWG cable (maximum). See Figure 2-9 on page 2–11 for torque requirements.

FROM AC DISTRIBUTION PANEL OR TRANSFER SWITCH

FROM GENERATOR

DISCONNECT

FROM AC LOAD ON INV1 FROM AC LOAD ON INV2 FROM AC LOAD ON INV3

INV 1 IN	INV 2 IN	INV 3 IN
(GRID)	(GRID)	(GRID)

INV	1 IN	INV	2 IN	INV	3 IN
(GEN)		(GEN)		(GEN)

	INV 1	OUT	INV 2	OUT	INV 3		OUT
(AC		LOADS)	(AC	LOADS)	(AC	LOADS)

TO AC1 ON INV1 TO AC1 ON INV2 TO AC1 ON INV3 TO AC2 ON INV1 TO AC2 ON INV2 TO AC2 ON INV3

TO INVERTER AC DISTRIBUTION

PANEL OR TRANSFER SWITCH

Figure 2-28Triple-Inverter AC Breaker Arrangement and Wiring Enlargement with Multiple AC Input Sources

2–36 975-0239-01-01