XW System Accessories Installation
CAUTION: Equipment damage
Connect the XW System Control Panel only to other
:
Although the cabling and connectors used in this network system are the same as Ethernet connectors, this network is not an Ethernet system. Equipment damage may result from attempting to connect these two different systems.
4.Connect the network cable(s) (and terminator if necessary) to either input on the back of the XW System Control Panel. See Figure
Connect a network terminator to the XW System Control Panel if it is the last device at the end of a
5.Place the unit in the opening and secure it with four #6 screws.
6.Peel off the protective plastic coating covering the screen and indicator light.
To surface mount the XW System Control Panel:
1.Using the supplied template sticker as a guide, mark the locations for two mounting screws and the access hole for the network cables.
2.Using a hole saw, cut out the access hole for the network cable(s).
3.Route the network cable(s) from other
4.Attach the mounting plate with two #6 screws.
5.Connect the network cable(s) (and terminator if necessary) to either input on the back of the XW System Control Panel.
Connect a network terminator to the XW System Control Panel if it is the last device at the end of a
6.Place the unit into the mounting plate and secure it with four #6 screws. See Figure
7.Peel off the protective plastic coating covering the screen and indicator light.
