Loading the system settings

Note

If you load the system settings, the settings currently configured are overwritten. If you do not want to erase the current settings, save the settings using the System Memory feature in advance.

Loading by the 7SYSTEM MEMORY

buttons

You can recall the system settings stored in “Memory1” to “Memory4” by pressing the corresponding 7SYSTEM MEMORY buttons.

1Press one of the 7SYSTEM MEMORY buttons on the remote control to select the desired memory number.

“Memory1 LOAD” (example) appears in the front panel display.

SYSTEM MEMORY

1 2 3 4

y

“Empty” appears in the menu screen if no system settings are stored in the selected memory number.

2Press the selected 7SYSTEM MEMORY button once more to confirm the selection.

This unit loads the settings stored in the selected memory number.

Loading by the GUI menu operation

1Follow steps 1 to 4 in “Saving by the GUI menu operation” (page 101).

2Press 9k / nrepeatedly to select “xxx Load” and then press 9h.

“xxx” indicates the zone you selected in step 1.

3Press 9k / nrepeatedly to select the desired memory number and then press 9h.

y

If the memory number you selected is empty, “Memory Empty” appears.

4Press 9ENTER to load the settings stored in the selected memory number.

y

To cancel the operation and return to the previous menu level, press 9l.

5Press IMENU to turn off the GUI menu.

Saving and recalling the system settings (System Memory)

Using examples

Example 1: Comparing the results of the

automatic setup and manual setup

This unit is equipped with three types of parametric equalizer settings (page 91), and you can also make your customized configuration of the sound settings of this unit by using the “Speaker” parameters (page 87). To compare the results of the automatic setup or your manual configuration, use the 7SYSTEM MEMORY buttons.

SYSTEM MEMORY 1

Results of the automatic setup (PEQ Select: Natural)

SYSTEM MEMORY 2 Results of the automatic setup (PEQ Select: Front)

SYSTEM MEMORY

1 2 3 4

SYSTEM MEMORY 3

Settings configured manually

Saving each setting

1Perform the automatic setup (page 30).

2Press and hold 7SYSTEM MEMORY 1 for 4 seconds.

This unit stores the results of the automatic setup (PEQ Select: Natural) to “Memory1”.

3Set “PEQ Select” to “Front” (page 91).

4Press and hold 7SYSTEM MEMORY 2 for 4 seconds.

This unit stores the results of the automatic setup (PEQ Select: Front) to “Memory2”.

5Configure the parameters of “Speaker” (page 87) and parametric equalizer configuration of each speaker manually (page 91).

6Press and hold 7SYSTEM MEMORY 3 for 4 seconds.

This unit stores the settings configured manually to “Memory3”.

OPERATION

ADVANCED

 

 

English

103 En