Optimizing the speaker setting for your listening room

Note

If an error or warning message appears, see “Error and warning messages” (page 32).

10Move the optimizer microphone to the

second listening position and then press 9ENTER to start the measurement.

y

To skip the measurements at the remaining listening positions, press 9n.

11Repeat step 10 until the measurement at all listening positions are made.

If you have made the measurement at all listening positions or skipped the measurement at the remaining listening positions, “Measurement Completed Successful” appears.

12Follow steps 7 to 9 in “Basic automatic setup” (page 31) to view the measurement results and turn off the GUI menu.

Reviewing and reloading the automatic setup parameters

Use this feature to review the result of the automatic setup. You can also reload the automatic setup parameters in case you are not satisfied with the speaker setup and sound adjustments you have configured manually.

Note

If you reload the automatic setup parameters, the settings you have configured manually are cleared. To save the settings before reloading the automatic setup parameters, see “System Memory” (page 101).

1Set the operation mode selector to FAMP and then press IMENU.

The GUI menu appears in the video monitor.

y

If the menu directory other than “Top Menu” (page 79) is displayed, press and hold IMENU to display the top GUI

menu.

2Press 9k / n repeatedly to select “Setup” and then press 9h.

3Press 9k / n repeatedly to select “Auto Setup” and then press 9h.

4Press 9k to select “Information” and then press 9h.

5Press 9k / n repeatedly to select the parameter of which you want to check the setting.

34 En