Parameter

Descriptions

 

 

Multi Measure

Displays the number of listening position

(Multiple point

actually measured.

measurement)

 

Optimizing the speaker setting for your listening room

Notes

• “–––” appears when no speaker is connected to the

corresponding speaker channel or this unit does not measure the

corresponding speaker channel yet.

• If you change speakers, speaker positions, or the layout of your

Wiring

(Speaker wiring)

Displays the polarity of each connected speaker.

–“NRM” appears when the polarity of the connected speaker is normal.

–“REV” appears when the polarity of the connected speaker is reversed.

–“DET” appears when this unit detects the subwoofer is connected.

–“–––” appears when no speaker is connected to the corresponding speaker channel.

listening environment, run the automatic setup again to

recalibrate your system.

• The distances displayed in the “Distance” results may be longer

than the actual distance depending on the characteristics of your

subwoofer or external amplifiers if you connect them.

• In the “Equalizing” results, different values may be set for the

same band to provide finer adjustments.

6 To reload the displayed parameter, press

9ENTER

PREPARATION

Distance

Displays the speaker distance from the

(Speaker

listening position. Press 9h repeatedly to

distance)

switch the unit to display the value of the

 

each speaker distance.

 

 

Size

Displays the size of the connected speakers

(Speaker size)

and the bass cross over frequency (“Cross”).

 

– “LRG” appears when the connected

 

speaker has the ability to reproduce the

 

low-frequency signals effectively.

 

– “SML” appears when the connected

 

speaker does not have the ability to

 

reproduce the low-frequency signals

 

effectively.

 

 

Equalizing

Displays the result of the adjustment of the

(Speaker

frequency responses of each connected

equalizing)

speaker. You can switch the parametric

 

equalizer type that appears in the result

 

display by pressing 9h repeatedly in the

 

“Equalizing” result display. To apply the

 

result that is displayed in the display, press

 

9ENTER.

 

Choices: Natural, Flat, Front

 

– Select “Natural” to average out the

 

frequency response of all speakers with

 

higher frequencies being less

 

emphasized. Recommended if the “Flat”

 

setting sounds a little harsh.

 

– Select “Flat” to average the frequency

 

response of all speakers. Recommended

 

if all of your speakers are of similar

 

quality.

 

– Select “Front” to adjust the frequency

 

response of each speaker in accordance

 

with the sound of your front speakers.

 

Recommended if your front speakers are

 

of much higher quality than your other

 

speakers.

 

 

Level

Displays the result of the adjustment of each

(Speaker level)

connected speaker output level. You can

 

display the result of the adjustment of the

 

speaker level for each parametric equalizer

 

type (see above) by pressing 9h

 

repeatedly. Select “Through” to display the

 

result when this unit does not use the

 

parametric equalizer.

 

 

y

The results of the measurement that are the causes of the warning message(s) appear in yellow or pink.

.

7 Press IMENU to turn off the GUI menu.

y

•You can also set the parametric equalizer type with “PEQ Select” (page 91).

•You can set the phase of the connected subwoofer with “Phase” (page 88).

English

35 En