Getting started

About this manual

y indicates a tip for your operation.

Some operations can be performed by using either the buttons on the front panel or the ones on the remote control. In case the button names differ between the front panel and the remote control, the button name on the remote control is given in parentheses.

This manual is printed prior to production. Design and specifications are subject to change in part as a result of improvements, etc. In case of differences between the manual and product, the product has priority.

AMASTER ON/OFF” or “3DVD” (example) indicates the name of the parts on the front panel or the remote control. Refer to the attached sheet or the pages at the end of this manual for the information about each position of the parts.

Installing batteries in the remote control

3 1

2

1Take off the battery compartment cover.

2Insert the four supplied batteries

(AAA, LR03, UM-4) according to the polarity markings (+ and –) on the inside of the battery compartment.

3Snap the battery compartment cover back into place.

Notes

Change all of the batteries if you notice the following conditions:

the operation range of the remote control decreases.

the transmit indicator does not flash or its light becomes dim.

Do not use old batteries together with new ones.

Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

Do not throw away batteries with general house waste; dispose of them correctly in accordance with your local regulations.

If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries, set up the remote control code and program any acquired functions that may have been cleared.

VOLTAGE SELECTOR

(Asia and General models only)

Caution

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.

Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver.

Voltages are as follows:

........................AC 110/120/220/230–240 V, 50/60 Hz

 

VOLTAGE

 

 

 

SELECTOR

 

 

230-

 

 

 

Voltage indication

 

 

 

 

 

 

 

240V

 

 

 

 

 

 

 

 

 

4 En