Troubleshooting
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
No sound is heard | “Bass Out” in “Configuration” is set to | Set “Bass Out” to “SWFR” or “Front + SWFR”. | ||
from the subwoofer. | “Front” when a Dolby Digital or DTS |
|
| |
| signal is being played. |
|
| |
|
|
|
| |
| “Bass Out” in “Configuration” is set to | Set “Bass Out” to “Front + SWFR”. | ||
| “SWFR” or “Front” when a |
|
| |
| source is being played. |
|
| |
|
|
|
| |
| The source does not contain low- |
|
| |
| frequency signals. |
|
| |
|
|
|
| |
No sound is heard | “Surround Back” in “Configuration” is set | Check whether “Surround” is set to “Small” or | ||
from the surround | to “None”. | “Large” and configure “Surround Back” properly. |
|
back speakers.
While this unit is in the CINEMA DSP 3D mode, no sound is output at the surround back speakers.
The audio input sources cannot be played in the desired digital audio signal format (Desired input source indicator or decoder indicator in the front panel display does not light up).
The connected component is not set to | Make an appropriate setting following the operating | — |
output the desired digital audio signals. | instructions for your component. |
|
|
|
|
Audio input jack select is set to | Set the audio input jack select to “AUTO”. | |
“ANALOG”. |
|
|
A humming sound is | Incorrect cable connections. | Connect the audio cables firmly. If the problem | — |
heard. |
| persists, the cables may be defective. |
|
|
|
|
|
| No connection from the turntable to the | Connect the grounding cable of the turntable to the | |
| GND terminal. | GND terminal of this unit. |
|
|
|
|
|
The volume level is | The record is being played on a turntable | Connect your turntable to this unit through an MC- | |
low while a record is | with an MC cartridge. | head amplifier. |
|
being played. |
|
|
|
|
|
|
|
The volume level | The component connected to the AUDIO | Turn on the power of the component. | — |
cannot be increased, | OUT (REC) jacks of this unit is turned |
|
|
or the sound is | off. |
|
|
distorted. |
|
|
|
|
|
|
|
A source cannot be | The audio source connected to the MULTI |
|
|
recorded by the | CH INPUT jacks of this unit cannot be |
|
|
recording component. | recorded. |
|
|
|
|
|
|
| A given input source is not output at the | Connect the recording component to another channel | |
| same output channel (e.g. DVR IN to | that is not being used for connecting the source |
|
| DVR OUT). | component. |
|
|
|
|
|
| You are trying to record a DTS source. | Make a setting so that the analog signal will be output | |
| (DTS signal is a digital bitstream. | from your |
|
| Attempting to record the DTS bitstream | the |
|
| digitally will result in noise being | while the recording component is connected to the |
|
| recorded.) | analog AUDIO OUT (DVR, VCR or |
|
|
| jacks. |
|
|
|
|
|