Connections
Setting the speaker impedance and GUI language
Caution
If you are to use 6 ohm speakers, set “SPEAKER IMP.” to “6Ω MIN” as follows BEFORE using this unit. You can also use 4 ohm speakers as the front speakers (page 121).
1Make sure this unit is turned off.
2Press and hold NSTRAIGHT on the front panel and then press AMASTER ON/OFF
inward to the ON position.
This unit turns on, and the advanced setup menu appears in the front panel display.
| While holding |
STRAIGHT | down |
EFFECT | MASTER |
|
3Rotate the MPROGRAM selector to select “SPEAKER IMP.”.
4Press NSTRAIGHT repeatedly to select “6Ω MIN”.
5Rotate the MPROGRAM selector to select “LANGUAGE”.
6Press NSTRAIGHT to select desired language setting for the GUI screen in the video monitor.
Choices: ENGLISH (English), JAPANESE, (Japanese), FRENCH (French), GERMAN (German), SPANISH (Spanish), RUSSIAN (Russian)
Notes
•For details about the display language, see “Language” (page 123)
•You can also select the display language with the GUI menu (page 100).
7Press AMASTER ON/OFF to release it outward to the OFF position to save the new setting and turn off this unit.
Note
The setting you made is reflected next time you turn on this unit.
■Turning on this unit
Press AMASTER ON/OFF on the front panel inward to the ON position.
When you turn on this unit by pressing AMASTER ON/ OFF, the main zone is turned on.
■Turning off this unit
Press AMASTER ON/OFF on the front panel again to release it outward to the OFF position.
■Set the main zone to the standby mode
Press BMAIN ZONE ON/OFF
(or DSTANDBY).
■Turning on the main zone from the standby mode
Press BMAIN ZONE ON/OFF (or EPOWER).
y
•Basically, we recommend that you use the standby mode to turn off this unit. In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.
•BMAIN ZONE ON/OFF, DSTANDBY and EPOWER are operational only when AMASTER ON/OFF is pressed inward to the ON position.
•When you turn on this unit, there will be a delay for a few seconds before this unit can reproduce sound.
If there are some problems...
•First, turn off and then turn on this unit again.
•If problems persist, initialize the parameters of this unit (page 138).