Zebra Technologies 2207A10L010, 2237A10L010 +28, PAUSE, Input, Input, label, Power, Ground, Output, REPRINT, SERVICE, REQUIRED, at 500 mA.), No function, on page 96), POWER GROUND, For the 24–28V

184Data Ports

Applicator Interface Connector

Table 22 • Applicator Interface Connector Pin Configuration (Continued)

Pin	Signal Name	Signal Type	Description
No.
5	PAUSE	Input	To toggle the current Pause state, this input must be
			asserted LOW for 200 milliseconds, or until the
			SERVICE REQUIRED output (pin 10) changes state.
6	REPRINT	Input	• If the Reprint feature is enabled, this input must be
			asserted LOW to cause the printer to reprint the last
			label.
			• If the Reprint feature is disabled, this input is ignored.
7	+28 V	Power	The Interface Power Supply. Supplies power to external
	(For the 5V board,		sensors as required.
	+28V is fused at 2 A.		Note • If operating with 28V signals only, pin 7
	For the 24–28V		may be used to supply power to pin 2, which
	board, +28V is fused		creates a non-isolated mode of operation. (This is
	at 500 mA.)		applicable for all printers except the
	Caution • Replace		110XiIIIPlus.)
	the fuse only with
	one of the same
	type and rating.
8	POWER GROUND	Ground	The Interface Power Ground.
	(+28 V DC Return)		Note • If pin 7 is used to supply power to pin 2,
			use this pin to ground pin 1. (This is applicable for
			all printers except the 110XiIIIPlus.)
9	—	—	No function.
10	SERVICE	Output	Asserted LOW in the following circumstances:
	REQUIRED		• the printhead is open
			• the ribbon or media is out
			• the printer is paused
			• an operational fault occurs
			• a Resynch error occurs while the applicator Resynch
			mode is set to Error mode (see Select Resynch Mode
			on page 96)

* Applicator boards have separate part numbers for the +5V version (49872-099M) and the +24-28V version (33361-099M).

13383L-004 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 9/6/07