Zebra Technologies 2207A10L010, 2237A10L010 (Non, VOID, modes, SPARE, RFID), Output, Output, Output, Output, Output, Output, (RFID), on page, on page, END PRINT, MEDIA OUT, RIBBON OUT, DATA READY

			Data Ports	185
			Applicator Interface Connector
	Table 22 • Applicator Interface Connector Pin Configuration (Continued)
Pin	Signal Name	Signal Type	Description
No.
11	END PRINT	Output	See Applicator Signals on page 181 for more information
			about the start and end print signals. See Set Applicator
			Port Mode on page 95 for more information about the
			modes.
			• MODE 0—The applicator port is OFF.
			• MODE 1—Asserted LOW only while the printer is
			moving the label forward; otherwise deasserted HIGH.
			• MODE 2—Asserted HIGH only while the printer is
			moving the label forward; otherwise deasserted LOW.
			• MODE 3—(Default) Asserted LOW for 20
			milliseconds when a label is completed and positioned.
			Not asserted during continuous printing.
			• MODE 4—Asserted HIGH for 20 milliseconds when a
			label is completed and positioned. Not asserted during
			continuous printing.
12	MEDIA OUT	Output	Asserted LOW while there is no media in the printer.
13	RIBBON OUT	Output	Asserted LOW while there is no ribbon in the printer.
14	DATA READY	Output	See Applicator Signals on page 181 for more information
			about this signal.
			• Asserted LOW when sufficient data has been received
			to begin printing the next label.
			• Deasserted HIGH whenever printing stops after the
			current label, due to either a pause condition or the
			absence of a label format.
15	SPARE	Output	To be determined.
(Non-
RFID)
15	VOID	Output	• Asserted LOW when the RFID transponder over the
(RFID)			antenna is “voided.”
			• Deasserted HIGH when the end print signal is asserted.

* Applicator boards have separate part numbers for the +5V version (49872-099M) and the +24-28V version (33361-099M).

9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A