Zebra Technologies 2207A10L010, 2237A10L010 FEED, MODE, MODE, ERROR, WEB S, MARK S, MEDIA S, RIBBON S, MARK LED, MEDIA LED, Feed Label, Head Close, TAKE LABEL, MARK MED S, RIBBON LED, Selections:

96Configuration

Control Panel Parameters

Table 10 • Printer Parameters (Sheet 25 of 27)

	Parameter			Action/Explanation
				Select Resynch Mode
RESYNCH MODE
				This parameter determines how the printer reacts if the label
-	FEED MODE		+	synchronization is lost and the label top is not where expected.
				Default: FEED MODE
				Selections: FEED MODE, ERROR MODE
				• FEED MODE—If the label top is not where expected, the printer feeds
				a blank label to find the label top position.
				• ERROR MODE—If the label top is not where expected, the printer
				stops, enters Pause mode, displays the message Error Condition
				Feed Label, flashes the ERROR light, and asserts the Service
				Required signal (pin 10 on the Applicator Interface Connector).
				To resynch the media to the top of the label in Error mode, press
				PAUSE to exit Pause mode. The ERROR light stops flashing, and the
				Service Required signal is deactivated. The action of the printer is
				determined by the Head Close configuration selection (see Select
				Head Close Option on page 91).
				To change the value shown:
				1. Press the left or right oval to toggle between the options.
				These parameters are automatically set during the calibration procedure
WEB S.		073		and should be changed only by a qualified service technician. Refer to the
-			+	ZPL II Programming Guide for information on these parameters.
				To skip these parameters:
MEDIA S.		075
-			+	1. Press NEXT/SAVE repeatedly.
RIBBON S.		071
-			+
TAKE LABEL
-			+
MARK S.		000
-			+
MARK MED S. 000
-			+
MEDIA LED		082
-			+
RIBBON LED		008
-			+
MARK LED		005
-			+

13383L-004 Rev. A XiIIIPlus/R110Xi/R170Xi User Guide 9/6/07