Zebra Technologies 2207A10L010, 2237A10L010 200 dpi, 300 dpi, 600 dpi, diameter, (8 dots/mm), 110XiIIIPlus, (12 dots/mm), (24 dots/mm), 203 dots/inch, 300 dots/inch, 600 dots/inch, 984 ft (300 m)

Specifications 203

Ribbon Specifications

Ribbon Specifications

Refer to the following tables for ribbon specifications.Note • Consider the following when using ribbon:

• Match the ribbon to the label width and printhead width that you are using. The ribbon should be at least as wide as the labels to protect the printhead from excessive wear.

• Ribbon must be wound with the coated side out.

110XiIIIPlus and R110Xi

Ribbon Specifications	110XiIIIPlus/R110Xi	110XiIIIPlus/R110Xi	110XiIIIPlus
	200 dpi	300 dpi	600 dpi
Printhead resolution	203 dots/inch	300 dots/inch	600 dots/inch
	(8 dots/mm)	(12 dots/mm)	(24 dots/mm)
Ribbon width Minimum	0.79 in. (20 mm)*	0.79 in. (20 mm)	0.79 in. (20 mm)
Ribbon width Maximum	4.33 in. (110 mm)	4.33 in. (110 mm)	3.40 in. (87 mm)
Standard length with 2:1	984 ft (300 m)	984 ft (300 m)	984 ft (300 m)
label to ribbon ratio
Standard length with 3:1	1476 ft (450 m)	1476 ft (450 m)	1476 ft (450 m)
label to ribbon ratio
Ribbon core inside	1.0 in. (25.4 mm)	1.0 in. (25.4 mm)	1.0 in. (25.4 mm)
diameter
Maximum ribbon roll	3.2 in. (81.3 mm)	3.2 in. (81.3 mm)	3.2 in. (81.3 mm)
outside diameter

* For RFID labels, the minimum ribbon width is determined by the minimum label width for the transponder being used.

9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A