Zebra Technologies 2207A10L010, 2237A10L010 Pin, Pin, Pinouts, +28V Input from Pin, Ground +28V from Pin, +24-28VExternal Input, External Ground +24-28V

Data Ports	187
Applicator Interface Connector

Pinouts for +24-28 V I/O Operation

Table 24 describes the pin configurations for +24–28 V I/O operation. There are no jumpers to configure for this mode.

Table 24 • Non-Isolated and Isolated Modes for +24–28V Operation

	Isolated (External Power)	Non-Isolated (Internal Printer Power)
Pin 1	External Ground +24-28V	Ground +28V from Pin 8
	I/O ground must be connected to an external	If pin 7 is used to supply power to pin 2, use
	ground.	pin 8 to ground pin 1.
	(Required for the 110XiIIIPlus.)	(Does not apply to the 110XiIIIPlus.)
Pin 2	+24-28V External Input	+28V Input from Pin 7
	+24-28 V I/O must be connected to an external	If operating with 28V signals only, pin 7 may
	power supply. This input also supplies voltage	be shorted to pin 2, which creates a
	for output signal pull-up resistors.	non-isolated mode of operation. This input
	(Required for the 110XiIIIPlus.)	also supplies voltage for output signal pull-up
		resistors.
		(Does not apply to the 110XiIIIPlus.)
Pinouts

+24-28V	1	+24-28V	+28V	1	+28V
	2			2
	3			3
	4			4
	5			5
+28V	6	+28V	+28V	6	+28V
500 mA	7		500 mA	7
	8			8
	9			9
	10			10
	11			11
	12			12
	13			13
	14			14
	15			15

9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A