Zebra Technologies 2207A10L010, 2237A10L010 Default:, Default:, PRINT WIDTH, - 104 0/8 MM, Set Print Width, Table 10 • Printer Parameters (Sheet 4 of 27)

			Configuration	75
			Control Panel Parameters
		Table 10 • Printer Parameters (Sheet 4 of 27)
Parameter			Action/Explanation
			Set Print Width
PRINT WIDTH
			Determines the printable area across the width of the label given the
- 104 0/8 MM	+
			resolution of the printer.
			Default: 104 0/8 MM
			Default: depends on specific printer
			Note • Setting the width too narrow can result in portions of the
			label not being printed on the media. Setting the width too wide
			wastes formatting memory and can cause printing off the label and
			on the platen roller. This setting can affect the horizontal position of
			the label format if the image was inverted using the ^POI ZPL II
			command.

To change the value shown:

1.Press the left oval to move the cursor.

2.Press the right oval to increase the value of the digit.

To change the unit of measurement:

1.Press the left oval until the unit of measurement is active.

2.Press the right oval to toggle to a different unit of measure (mm, inches, or dots).

9/6/07 XiIIIPlus/R110Xi/R170Xi User Guide 13383L-004 Rev. A