Introduction 25

ZT230 Printer Control Panel Display

TOOLS Menu (continued)

Items in this menu are shown in the order in which they appear when you press the RIGHT ARROW. For more information about these settings, see Table 8, Calibration and Diagnostic Tools on page 83.

 

 

 

Set the Head-Close Action

 

 

 

 

 

 

Set the action for the printer to take when you close the printhead.

▼

HEAD CLOSE ACTION

▲

See Head-Close Action on page 85 for more information.

CALIBRATE

 

 

 

 

 

 

 

 

LOAD DEFAULTS

▼ FACTORY ▲

LOAD

MEDIA/RIBBON CAL

START

DIAGNOSTIC MODE

▼ DISABLED ▲

Load Printer Defaults*

Use this menu item to restore all settings other than the network settings back to the factory defaults. Use care when loading defaults because you will need to reload all settings that you changed manually.

See Load Defaults on page 86 for more information.

* Other options are available by scrolling.

Calibrate the Media and Ribbon Sensors

Use this menu item to adjust the sensitivity of the media and ribbon sensors.

See Media and Ribbon Sensor Calibration on page 87 for more information. For instructions on how to perform a calibration procedure, see Calibrate the Ribbon and Media Sensors

on page 98.

Enable Communication Diagnostics Mode

Use this diagnostics tool to cause the printer to output the hexadecimal values for all data received by the printer.

See Communication Diagnostics Mode on page 87 for more information.

8/22/12

P1048261-004