50Printer Setup and Operation Connect the Printer to a Power Source

3.Turn on (I) the printer.

The printer boots up and performs a self-test. The printer reports its status through the indicator lights on the control panel (see Table 14 on page 127 for the meaning of the light colors and combinations).

Power Cord Specifications

Caution • For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific, three-conductor grounded plug configuration.

Depending on how your printer was ordered, a power cord may or may not be included. If one is not included or if the one included is not suitable for your requirements, see Figure 9 and refer to the following guidelines:

•The overall cord length must be less than 9.8 ft. (3 m).

•The cord must be rated for at least 10 A, 250 V.

•The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic interference.

P1048261-004

8/22/12