34Introduction
ZT230 Printer Control Panel Display
SENSORS Menu
Items in this menu are shown in the order in which they appear when you press the RIGHT ARROW. For more information about these settings, see Table 11, Sensor Settings
|
|
| Select the Media Sensor |
|
|
| |
|
|
| Select the media sensor that is appropriate for the media that you |
| SENSOR TYPE |
| are using. The reflective sensor can be used with all media types. |
▼ | REFLECTIVE | ▲ | The transmissive sensor should be used only for simple gap media. |
|
|
| See Sensor Type on page 95 for more information. |
|
|
|
|
|
|
|
|
MEDIA/RIBBON CAL
START
▼ | PRINT INFORMATION | ▲ |
SENSOR PROFILE | ||
|
|
|
|
| |
|
|
|
LABEL SENSOR
▼ 000▲
Calibrate the Media and Ribbon Sensors
Use this menu item to adjust the sensitivity of the media and ribbon sensors.
For instructions on how to perform a calibration procedure, see Calibrate the Ribbon and Media Sensors on page 98.
Print a Sensor Profile*
Use this menu item to print a sensor profile.
See Print Information on page 83 or Sensor Profile on page 149 for more information.
* Other options are available by scrolling.
Set the Sensitivity of the Label Sensor
Important • This value is set during sensor calibration. Do not change this setting unless you are told to do so by Zebra Technical Support or by an authorized service technician.
See Label Sensor on page 95 for more information.
8/22/12 |