ZyXEL Communications 100WH user manual TCP/IP Ethernet and Dhcp Setup, IP Address and Subnet Mask

Prestige 100WH Internet Access Router

The General Setup menu allows you to define the filter sets that you wish to apply to your Ethernet traffic. From Menu 3 - Ethernet Setup, enter 1 to go to Menu 3.1 -General Ethernet Setup.

Menu 3.1 - General Ethernet Setup

Input Filter Sets=

Output Filter Sets=

Press ENTER to Confirm or ESC to Cancel:

Figure 3-2. Menu 3.1 - General Ethernet Setup

Filters are not required for your Prestige to function properly. However, input and output filter sets may be useful to block certain packets, reduce traffic, and prevent a security breach on your Ethernet.

If you have a need for filters, read about Chapter 7 - Filter Set Configuration, then return to this menu to define the appropriate filter sets.

3.2TCP/IP Ethernet and DHCP Setup

3.2.1IP Address and Subnet Mask

The Prestige is pre-configured in the factory with an IP address of 192.168.1.1 and a subnet mask of 255.255.255.0 (Class C). This setup should work fine for the basic Internet access application. It is strongly recommend that you do not change them, unless your ISP or network administrator assigns you a block of registered IP addresses.

3-2Chapter 3 Internet Access Application