Chapter 14 Filters
Figure 82 Security > Filter > IP/MAC Filter
The following table describes the labels in this screen.
Table 62 Security > Filter > IP/MAC Filter
LABEL | DESCRIPTION |
Rule Type |
|
|
|
Rule Type selection | Select White List to specify traffic to allow and Black List to specify traffic to |
| disallow. |
|
|
IP / MAC Filter Rule Editing |
|
|
|
IP / MAC Filter Rule Index | Select the index number of the filter rule. |
|
|
Active | Use this field to enable or disable the filter rule. |
|
|
Interface | Select the PVC to which to apply the filter. |
|
|
Direction | Apply the filter to Incoming or Outgoing traffic direction. |
|
|
Rule Type | Select IP or MAC type to configure the rule. |
| Use the IP Filter to block or allow traffic by IP addresses. |
| Use the MAC Filter to block or allow traffic by MAC address. |
|
|
Source IP Address | Enter the source IP address of the packets you wish to filter. This field is |
| ignored if it is 0.0.0.0. |
|
|
Subnet Mask | Enter the IP subnet mask for the source IP address |
|
|
Port Number | Enter the source port of the packets that you wish to filter. The range of this |
| field is 0 to 65535. This field is ignored if it is 0. |
|
|
Destination IP Address | Enter the destination IP address of the packets you wish to filter. This field is |
| ignored if it is 0.0.0.0. |
|
|
164 |
|
|
|