Chapter 14 Filters
14.3 IPv6/MAC Filter
Use this screen to create and apply IPv6 filters. Click Security > Filter > IPv6/MAC Filter. The screen appears as shown.
Figure 83 Security > Filter > IPv6/MAC Filter
The following table describes the labels in this screen.
Table 63 Security > Filter > IPv6/MAC Filter
LABEL | DESCRIPTION |
Rule Type |
|
|
|
Rule Type selection | Select White List to specify traffic to allow and Black List to specify traffic to |
| block. |
|
|
IPv6 / MAC Filter Rule Editing |
|
|
|
IPv6 / MAC Filter Rule Index | Select the index number of the filter rule. |
|
|
Active | Use this field to enable or disable the filter rule. |
|
|
Interface | Select the PVC to which to apply the filter. |
|
|
Direction | Apply the filter to Incoming or Outgoing traffic direction. |
|
|
Rule Type | Select IP or MAC type to configure the rule. |
| Use the IP Filter to block or allow traffic by IPv6 addresses. |
| Use the MAC Filter to block or allow traffic by MAC address. |
|
|
Source IP Address | Enter the source IPv6 address of the packets you wish to filter. This field is |
| ignored if it is ::. |
|
|
Source Prefix Length | Enter the prefix length for the source IPv6 address |
|
|
Destination IPv6 Address | Enter the destination IPv6 address of the packets you wish to filter. This field is |
| ignored if it is ::. |
|
|
166 |
|
|
|