Chapter 1 Introduction

WPS

3Press the WPS button on another WPS-enabled device within range of the AMG1312-T Series. The WPS LED should flash while the AMG1312-T Series sets up a WPS connection with the other wireless device.

4Once the connection is successfully made, the WPS LED shines green.

1.7The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the user name and password will be reset to the default.

1.7.1 Using the Reset Button

1Make sure the POWER LED is on (not blinking).

2To set the device back to the factory default settings, press the RESET button for ten seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts.

1.8Ways to Manage the AMG1312-T Series

Use any of the following methods to manage the AMG1312-T Series.

•Web Configurator. This is recommended for everyday management of the AMG1312-T Series using a (supported) web browser.

•FTP for firmware upgrades and configuration backup/restore.

18

 

AMG1312-T Series User’s Guide