Chapter 21 Policy Rule
Table 51 Advanced Application > Policy Rule (continued)
LABEL | DESCRIPTION |
Rate Limit | Select Enable to activate bandwidth limitation on the traffic flow(s). |
|
|
Add | Click Add to inset the entry to the summary table below and save your |
| changes to the Switch’s |
| if it is turned off or loses power, so use the Save link on the top navigation |
| panel to save your changes to the |
| done configuring. |
|
|
Cancel | Click Cancel to reset the fields back to your previous configuration. |
|
|
Clear | Click Clear to set the above fields back to the factory defaults. |
|
|
Index | This field displays the policy index number. Click an index number to edit |
| the policy. |
|
|
Active | This field displays Yes when policy is activated and No when is it |
| deactivated. |
|
|
Name | This field displays the name you have assigned to this policy. |
|
|
Classifier(s) | This field displays the name(s) of the classifier to which this policy applies. |
|
|
Delete | Click Delete to remove the selected entry from the summary table. |
|
|
Delete | Click Cancel to clear the Delete check boxes. |
|
|
Cancel | This field displays the policy index number. Click an index number to edit |
| the policy. |
|
|
21.2.1 Viewing and Editing Policy Configuration
To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Policy screen. To change the settings of a rule, click a number in the Index field.
Figure 95 Advanced Application > Policy Rule: Summary Table
184 |
| |
| ||
|
|
|