Chapter 24 AAA
Table 61 Advanced Application > AAA > TACACS+ Server Setup (continued)
LABEL | DESCRIPTION |
Timeout | Specify the amount of time in seconds that the Switch waits for an |
| authentication request response from the TACACS+ server. |
| If you are using |
| using two TACACS+ servers then the timeout value is divided between |
| the two TACACS+ servers. For example, if you set the timeout value to |
| 30 seconds, then the Switch waits for a response from the first TACACS+ |
| server for 15 seconds and then tries the second TACACS+ server. |
|
|
Index | This is a |
|
|
IP Address | Enter the IP address of an external TACACS+ server in dotted decimal |
| notation. |
|
|
TCP Port | The default port of a TACACS+ server for authentication is 49. You need |
| not change this value unless your network administrator instructs you to |
| do so. |
|
|
Shared Secret | Specify a password (up to 32 alphanumeric characters) as the key to be |
| shared between the external TACACS+ server and the Switch. This key is |
| not sent over the network. This key must be the same on the external |
| TACACS+ server and the Switch. |
|
|
Delete | Check this box if you want to remove an existing TACACS+ server entry |
| from the Switch. This entry is deleted when you click Apply. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
214 |
| |
| ||
|
|
|