Chapter 27 Layer 2 Protocol Tunneling
27.2 Configuring Layer 2 Protocol Tunneling
Click Advanced Application > Layer 2 Protocol Tunneling in the navigation panel to display the screen as shown.
Figure 136 Advanced Application > Layer 2 Protocol Tunneling
The following table describes the labels in this screen.
Table 78 Advanced Application > Layer 2 Protocol Tunneling
LABEL | DESCRIPTION |
Active | Select this to enable layer 2 protocol tunneling on the Switch. |
|
|
Destination | Specify a MAC address with which the Switch uses to encapsulate the |
MAC Address | layer 2 protocol packets by replacing the destination MAC address in the |
| packets. |
| Note: The MAC address can be either a unicast MAC address or |
| multicast MAC address. If you use a unicast MAC address, |
| make sure the MAC address does not exist in the address |
| table of a switch on the service provider’s network. |
| Note: All the edge switches in the service provider’s network should |
| be set to use the same MAC address for encapsulation. |
|
|
| 253 |
|
|