Chapter 38 Configure Clone
The following table describes the labels in this screen.
Table 111 Management > Configure Clone
LABEL | DESCRIPTION |
Source/ | Enter the source port under the Source label. This port’s attributes are |
Destination | copied. |
Port | Enter the destination port or ports under the Destination label. These are |
| the ports which are going to have the same attributes as the source port. |
| You can enter individual ports separated by a comma or a range of ports by |
| using a dash. |
| Example: |
| • 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports. |
| • |
|
|
Basic | Select which port settings (you configured in the Basic Setting menus) |
Setting | should be copied to the destination port(s). |
|
|
Advanced | Select which port settings (you configured in the Advanced Application |
Application | menus) should be copied to the destination ports. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
326 |
| |
| ||
|
|
|