Chapter 32 Access Control
32.4 Configuring SNMP Trap Group
Use the Trap Group screen to specify the types of SNMP traps that should be sent to each SNMP manager.
Click Management > Access Control > SNMP > Trap Group to view the screen as shown.
Figure 158 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Table 91 Management > Access Control > SNMP > Trap Group
LABEL | DESCRIPTION |
Trap | Select one of your configured trap destination IP addresses. These are |
Destination IP | the IP addresses of the SNMP managers. You must first configure a trap |
| destination IP address in the SNMP Setting screen. |
| Use the rest of the screen to select which traps the Switch sends to that |
| SNMP manager. |
|
|
Type | Select the categories of SNMP traps that the Switch is to send to the |
| SNMP manager. |
|
|
Options | Select the individual SNMP traps that the Switch is to send to the SNMP |
| station. See Section on page 293 for individual trap descriptions. |
| The traps are grouped by category. Selecting a category automatically |
| selects all of the category’s traps. Clear the check boxes for individual |
| traps that you do not want the Switch to send to the SNMP station. |
| Clearing a category’s check box automatically clears all of the category’s |
| trap check boxes (the Switch only sends traps from selected categories). |
| Note: The poe and fanspeed options are only available to GS2200- |
| 24P. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
| 287 |
|
|