Chapter 7 System Status and Port Statistics
The following table describes the labels in this screen.
Table 7 Status
LABEL | DESCRIPTION |
Port | This identifies the Ethernet port. Click a port number to display the Port |
| Details screen (refer to Figure 37 on page 70). |
|
|
Name | This is the name you assigned to this port in the Basic Setting > Port |
| Setup screen. |
|
|
Link | This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps |
| or 1000M for 1000Mbps) and the duplex (F for full duplex or H for half). |
| It also shows the cable type (Copper or Fiber) for the combo ports. |
|
|
State | If STP (Spanning Tree Protocol) is enabled, this field displays the STP |
| state of the port (see Section 13.1 on page 123 for more information). |
| If STP is disabled, this field displays FORWARDING if the link is up, |
| otherwise, it displays STOP. |
|
|
PD | (for |
| device (PD) is allowed to receive power from the Switch on this port. |
|
|
LACP | This fields displays whether LACP (Link Aggregation Control Protocol) has |
| been enabled on the port. |
|
|
TxPkts | This field shows the number of transmitted frames on this port. |
|
|
RxPkts | This field shows the number of received frames on this port. |
|
|
Errors | This field shows the number of received errors on this port. |
|
|
Tx KB/s | This field shows the number of kilobytes per second transmitted on this |
| port. |
|
|
Rx KB/s | This field shows the number of kilobytes per second received on this port. |
|
|
Up Time | This field shows the total amount of time in hours, minutes and seconds |
| the port has been up. |
|
|
Clear Counter | Enter a port number and then click Clear Counter to erase the recorded |
| statistical information for that port, or select Any to clear statistics for all |
| ports. |
|
|
| 69 |
|
|