Chapter 9 VLAN
Refer to the following figure. Suppose you want to create VLAN groups 1 and 2 (V1 and V2) on devices A and B. Without VLAN Trunking, you must configure VLAN groups 1 and 2 on all intermediary switches C, D and E; otherwise they will drop frames with unknown VLAN group tags. However, with VLAN Trunking enabled on a port(s) in each intermediary switch you only need to create VLAN groups in the end devices (A and B). C, D and E automatically allow frames with VLAN group tags 1 and 2 (VLAN groups that are unknown to those switches) to pass through their VLAN trunking port(s).
Figure 47 Port VLAN Trunking
9.1.2.3 Select the VLAN TypeSelect a VLAN type in the Basic Setting > Switch Setup screen.
Figure 48 Switch Setup > Select VLAN Type
Static VLAN
Use a static VLAN to decide whether an incoming frame on a port should be
•sent to a VLAN group as normal depending on its VLAN tag.
•sent to a group whether it has a VLAN tag or not.
•blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified VID.
96 |
| |
| ||
|
|
|