Chapter 3 Hardware Panels
To avoid possible eye injury, do not look into an operating fiber- optic module’s connectors.
•Type: SFP connection interface
•Connection speed: 1 Gigabit per second (Gbps)
3.2.3.1Transceiver InstallationUse the following steps to install a
1Insert the transceiver into the slot with the exposed section of PCB board facing down.
2Press the transceiver firmly until it clicks into place.
3The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning properly.
4Close the transceiver’s latch (latch styles vary).
5Connect the fiber optic cables to the transceiver.
Figure 9 Transceiver Installation Example
Figure 10 Connecting the Fiber Optic Cables
3.2.3.2 Transceiver RemovalUse the following steps to remove a
1Remove the fiber optic cables from the transceiver.
2Open the transceiver’s latch (latch styles vary).
| 37 |
|
|