Chapter 3 Hardware Panels
3Pull the transceiver out of the slot.
Figure 11 Removing the Fiber Optic Cables
Figure 12 Opening the Transceiver’s Latch Example
Figure 13 Transceiver Removal Example
3.2.4Power Connector
Note: Make sure you are using the correct power source as shown on the panel.
To connect power to the Switch, insert the female end of the power cord to the AC power receptacle on the front panel. Connect the other end of the supplied power cord to a power outlet. Make sure that no objects obstruct the airflow of the fans (located on the side of the unit).
See Chapter 40 on page 333 for information on the Switch’s power supply requirements.
3.3 LEDs
After you connect the power to the Switch, view the LEDs to ensure proper functioning of the Switch and as an aid in troubleshooting.
Table 3 | LED Descriptions |
|
| |
LED |
| COLOR | STATUS | DESCRIPTION |
PWR |
| Green | On | The system is turned on. |
|
|
|
|
|
|
|
| Off | The system is off or has failed. |
|
|
|
|
|
38 |
| |
| ||
|
|
|