Chapter 3 Status Screens
Table 4 The Status Screen
LABEL | DESCRIPTION |
System Information |
|
|
|
System Name | This field displays the NWA system name. It is used for |
| identification. You can change this in the System > General |
| screen’s System Name field. |
|
|
Model | This field displays the NWA’s exact model name. |
|
|
Firmware Version | This field displays the current version of the firmware inside the |
| device. It also shows the date the firmware version was created. |
| You can change the firmware version by uploading new firmware |
| in Maintenance > F/W Upload. |
|
|
System Up Time | This field displays the elapsed time since the NWA was turned on. |
|
|
Current Date Time | This field displays the date and time configured on the NWA. You |
| can change this in the System > Time Setting screen. |
|
|
WLAN1 Operating | This field is not available when the NWA is in AP controller |
Mode | management mode. |
| This field displays the current operating mode of the first wireless |
| module (AP, Bridge / Repeater, AP + Bridge or MBSSID). You |
| can change the operating mode in the Wireless > Wireless |
| screen. |
|
|
WLAN2 Operating | This field is not available when the NWA is in AP controller |
Mode | management mode. |
| This field displays the current operating mode of the second |
| wireless module (AP, Bridge / Repeater, AP + Bridge or |
| MBSSID). You can change the operating mode in the Wireless > |
| Wireless screen. |
|
|
Management VLAN | This field displays the management VLAN ID if VLAN is active, or |
| Disabled if it is not active. You can enable or disable VLAN, or |
| change the management VLAN ID, in the VLAN > Wireless |
| VLAN screen. |
|
|
Rogue AP | This field is available only when the NWA is in AP controller |
Detection | management mode. |
| This field displays whether rogue AP detection is turned on |
| (Enable) or not (Disable). |
|
|
IP | This field displays the current IP address of the NWA on the |
| network. |
|
|
LAN MAC | This displays the MAC (Media Access Control) address of the NWA |
| on the LAN. Every network device has a unique MAC address |
| which identifies it across the network. Your NWA features dual |
| wireless module, and has two MAC addresses. The MAC address of |
| the first wireless module (WLAN1) is used on the LAN. |
|
|
WLAN1 MAC | This field is not available when the NWA is in AP controller |
| management mode. |
| This displays the MAC address of the first wireless module. |
|
|
WLAN2 MAC | This field is not available when the NWA is in AP controller |
| management mode. |
| This displays the MAC address of the second wireless module. |
|
|
| 41 |
|
|