Chapter 6 Tutorial
6.2.3.3 Activate the Guest Profile
You need to activate the Guest_SSID profile before it can be used. Click the Wireless tab. In the Select SSID Profile table, select the check box for the Guest_SSID profile and click Apply.
Figure 46 Tutorial: Activate Guest Profile
Your guest wireless network is now ready to use.
6.2.4 Testing the Wireless Networks
To make sure that the three networks are correctly configured, do the following.
•On a computer with a wireless client, scan for access points. You should see the Guest_SSID network, but not the VoIP_SSID network. If you can see the VoIP_SSID network, go to its SSID Edit screen and make sure Hide Name (SSID) is set to Enable.
Whether or not you see the standard network’s SSID (SSID04) depends on whether “hide SSID” is enabled.
•Try to access each network using the correct security settings, and then using incorrect security settings, such as the
•Access the Guest_SSID network and try to access other resources than those specified in the Layer 2 Isolation (l2isolation01) profile screen.
You can use the ping utility to do this. Click Start > Run... and enter “cmd” in the Open: field. Click OK. At the c:\> prompt, enter “ping 192.168.1.10” (substitute the IP address of a real device on your network that is not on the layer 2 isolation list). If you receive a reply, check the settings in the WIRELESS >
82 |
| |
| ||
|
|
|