Chapter 5 Controller AP Mode
5.6 Redundancy Screen
Use this screen to set the controller AP as a primary or secondary controller.
If you set your NWA as a primary controller AP, you can have a secondary controller AP to serve as a backup. All configurations are synchronized between the NWA and the secondary controller AP.
When the NWA is in AP controller mode, click CONTROLLER > Redundancy. The following screen displays.
Figure 28 The Controller > Configuration Screen
The following table describes the labels in this screen.
Table 12 The Controller > Redundancy Screen
LABEL | DESCRIPTION |
Redundancy | Select Enable to set the NWA either as a Primary AP |
| Controller or as a Secondary Controller AP. |
| Select Disable when the NWA acts as a primary AP |
| controller without a backup. |
|
|
Primary AP Controller | Select this if the NWA has a secondary controller AP. You |
| must give the IP address of this backup in the field below. |
|
|
Secondary IP | Enter the IP address of the secondary controller AP. |
|
|
Secondary AP Controller | Select this if the NWA is the secondary controller AP. |
|
|
Apply | Click this to save the changes in this screen. |
|
|
Reset | Click this to return the fields in this screen to their |
| |
|
|
| 61 |
|
|