ZyXEL Communications Prestige100 user manual

∙B Channel Usage - Determine which connection is appropriate for your B channel and check the corresponding option on the worksheet.

If your Prestige is the only device using the ISDN line, then configure B Channel Usage to ‘Switch/Switch’ so that your device will use both B channels to communicate. If your Prestige is sharing the ISDN line with other devices, then configure B Channel to “Switch/Unused”.

∙Telephone Number(s) - Record on the worksheet the telephone number(s) given to you by your ISDN provider. Some switch types only have one telephone number. These phone numbers should be in a standard digit format (for example, 5551212). Please note that these fields will only accept digits, so ‘-’ and spaces will not be accepted.

∙Analog Call - Check the appropriate ‘Analog Call’ option on the worksheet for each telephone number. This information is later used to configure the Prestige in routing an incoming analog call. Set to ‘Phone1’ or ‘Phone2’ if you wish to route the incoming analog call for this telephone number to PHONE port number 1 or 2.

∙SPID Number(s) - (For North America only) The SPID (Service Profile Identifier) is a number used by a central office switch for identification purposes. With the switch information, please see the previous table for the number of SPIDs you must enter.

You have now collected all of the necessary information about your ISDN phone line. Make sure that these values are entered into your worksheet before you continue to the next section. For DSS1 and 1TR6 ISDN, please refer to Chapter 3.

Before You Begin 13