ZyXEL Communications Prestige100 user manual Prestige Front Panel

∙Crossover cable (red tag): Connect your Prestige to your computer directly without a hub.

:DUQLQJ￿ ,I￿WKLV￿FDEOH￿LV￿XVHG￿WR￿FRQQHFW￿,6'1￿￿LW￿PD\￿GDPDJH￿\RXU￿3UHVWLJH￿

∙AUI

The AUI port (the connector with 15 pins) is used to connect the Prestige to a 10Base5 (thicknet) network.

If you have a 10Base2 network using BNC connectors and thin coaxial cables, you will need a transceiver between the AUI port and the 10Base2 cabling.

Connecting a Power Adapter to your Prestige

Plug the power adapter into the outlet on the rear panel of the

Prestige labeled ‘POWER’.

At this point, you should have connected the RS-232 cable, the ISDN phone line, the Ethernet cable, and the power supply. You can now power on your Prestige.

Prestige Front Panel

Names and descriptions of the Prestige front panel LED's are listed below:

Figure 3-2 Front Panel

PWR - This LED (power) comes on as soon as you connect you Prestige to the power supply and switch it to the ‘I’ (on) position.

TST - The TST (Test) LED should be blinking if the Prestige is functioning properly.

24 Installation