ZyXEL Communications Prestige100 user manual Connecting Your Computer and Your Prestige

the correct cable for each connection; otherwise, your Prestige could be damaged.

Connecting Your Computer and Your Prestige

For the initial setup of your Prestige, you must use RS-232 and communication software to configure the Prestige.

After the Prestige has been successfully installed, you can modify the configuration through a remote Telnet connection. See Chapter 10 for detailed instructions on using Telnet to configure your Prestige.

Connecting the RS-232 Cable to your Prestige

One 9-25 pin adapter is included in your package. To connect a RS-232 cable, connect the 9-pin end of the cable to the DTE port on the back panel of the Prestige. Connect the other end to the RS- 232 cable connected to the serial port (COM1, COM2, or any other COM port) of your computer.

Connecting an ISDN Line to your Prestige

Plug one end of your ISDN phone line which is included in your package into the socket on the rear panel of the Prestige labeled ‘ISDN’ and the other end into the ISDN wall jack.

∙S/T interface - This can only connect to your NT-1 (Network Termination) device.

:DUQLQJ￿ 'R￿QRW￿XQGHU￿DQ\￿FLUFXPVWDQFHV￿FRQQHFW￿GLUHFWO\￿WR￿WKH￿,6'1￿ZDOO￿MDFN￿

∙U interface - This allows you to connect directly to your ISDN wall jack.

:DUQLQJ￿ 7KH￿,6'1￿MDFN￿LV￿IRU￿,6'1￿OLQH￿FRQQHFWLRQ￿RQO\￿￿&RQQHFWLRQ￿RI￿D￿SKRQH￿OLQH PD\￿UHVXOW￿LQ￿GDPDJH￿WR￿\RXU￿3UHVWLJH￿

22 Installation