|
| Chapter 20 Classifier | |
|
|
|
|
| Table 49 | Advanced Application > Classifier (continued) | |
| LABEL | DESCRIPTION |
|
| Packet | Specify the format of the packet. Choices are All, 802.3 tagged, 802.3 |
|
| Format | untagged, Ethernet II tagged and Ethernet II untagged. | |
|
| A value of 802.3 indicates that the packets are formatted according to the | |
|
| IEEE 802.3 standards. | |
|
| A value of Ethernet II indicates that the packets are formatted according to | |
|
| RFC 894, Ethernet II encapsulation. | |
|
|
|
|
| Layer 2 |
|
|
Specify the fields below to configure a
VLAN | Select Any to classify traffic from any VLAN or select the second option and |
| specify the source VLAN ID in the field provided. |
|
|
Priority | Select Any to classify traffic from any priority level or select the second option |
| and specify a priority level in the field provided. |
|
|
Ethernet | Select an Ethernet type or select Other and enter the Ethernet type number in |
Type | hexadecimal value. Refer to Table 51 on page 207 for information. |
|
|
Source |
|
|
|
MAC | Select Any to apply the rule to all MAC addresses. |
Address | To specify a source, select the second choice and type a MAC address in valid |
| |
| MAC address format (six hexadecimal character pairs). |
|
|
Port | Type the port number to which the rule should be applied. You may choose one |
| port only or all ports (Any). |
|
|
Destination | |
|
|
MAC | Select Any to apply the rule to all MAC addresses. |
Address | To specify a destination, select the second choice and type a MAC address in |
| |
| valid MAC address format (six hexadecimal character pairs). |
|
|
Layer 3 |
|
Specify the fields below to configure a
DSCP | Select Any to classify traffic from any DSCP or select the second option and |
| specify a DSCP (DiffServ Code Point) number between 0 and 63 in the field |
| provided. |
|
|
IP | Select an IP protocol type or select Other and enter the protocol number in |
Protocol | decimal value. Refer to Table 52 on page 207 for more information. |
| You may select Establish Only for TCP protocol type. This means that the |
| Switch will pick out the packets that are sent to establish TCP connections. |
|
|
Source |
|
|
|
IP | Enter a source IP address in dotted decimal notation. |
Address/ | Specify the address prefix by entering the number of ones in the subnet mask. |
Address |
|
Prefix |
|
|
|
| 205 |
|
|