Chapter 45 Access Control
The following table describes the labels in this screen.
Table 150 Management > Access Control > SNMP
LABEL | DESCRIPTION |
General Setting | Use this section to specify the SNMP version and community (password) |
| values. |
|
|
Version | Select the SNMP version for the Switch. The SNMP version on the Switch |
| must match the version on the SNMP manager. Choose SNMP version 2c |
| (v2c), SNMP version 3 (v3) or both (v3v2c). |
| Note: SNMP version 2c is backwards compatible with SNMP |
| version 1. |
|
|
Get Community | Enter the Get Community string, which is the password for the |
| incoming Get- and GetNext- requests from the management station. |
| The Get Community string is only used by SNMP managers using |
| SNMP version 2c or lower. |
|
|
Set Community | Enter the Set Community string, which is the password for the |
| incoming Set- requests from the management station. |
| The Set Community string is only used by SNMP managers using |
| SNMP version 2c or lower. |
|
|
Trap | Enter the Trap Community string, which is the password sent with |
Community | each trap to the SNMP manager. |
| The Trap Community string is only used by SNMP managers using |
| SNMP version 2c or lower. |
|
|
Trap | Use this section to configure where to send SNMP traps from the Switch. |
Destination |
|
|
|
Version | Specify the version of the SNMP trap messages. |
|
|
IP | Enter the IP addresses of up to four managers to send your SNMP traps |
| to. |
|
|
Port | Enter the port number upon which the manager listens for SNMP traps. |
|
|
Username | Enter the username to be sent to the SNMP manager along with the |
| SNMP v3 trap. |
| Note: This username must match an existing account on the Switch |
| (configured in the Management > Access Control > SNMP |
| > User screen). |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
| 403 |
|
|