Chapter 30 sFlow
more than one collector if the traffic load to be monitored is more than one collector can manage.
Figure 147 Advanced Application > sFlow > Collector
The following table describes the labels in this screen.
Table 94 Advanced Application > sFlow > Collector
LABEL | DESCRIPTION |
Collector | Enter the IP address of the sFlow collector. |
Address |
|
|
|
UDP Port | Enter a UDP port number the Switch uses to send sFlow datagram to the |
| collector. If you change the port here, make sure you change it on the |
| collector, too. The default port is 6343. |
|
|
Add | Click Add to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to reset the fields to your previous configuration. |
|
|
Clear | Click Clear to reset the fields to the factory defaults. |
|
|
Index | This field displays the index number of this entry. |
|
|
Collector | This field displays IP address of the sFlow collector. |
Address |
|
|
|
UDP Port | This field displays port number the Switch uses to send sFlow datagram to |
| the collector. |
|
|
Delete | Check the rule(s) that you want to remove in the Delete column and then |
| click the Delete button. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
300 |
| |
| ||
|
|
|