|
|
| Chapter 39 Differentiated Services |
|
|
|
|
| Table 126 | IP Application > DiffServ > | |
| LABEL |
| DESCRIPTION |
| Commit |
| Specify the Commit Information Rate (CIR) for this port. |
| Rate |
|
|
|
|
|
|
| Peak |
| Specify the Peak Information Rate (PIR) for this port. |
| Rate |
|
|
|
|
|
|
| DSCP |
| Use this section to specify the DSCP values that you want to assign to packets |
|
|
| based on the color they are marked via TRTCM. |
|
|
|
|
| green |
| Specify the DSCP value to use for packets with low packet loss priority. |
|
|
|
|
| yellow |
| Specify the DSCP value to use for packets with medium packet loss priority. |
|
|
|
|
| red |
| Specify the DSCP value to use for packets with high packet loss priority. |
|
|
|
|
| Apply |
| Click Apply to save your changes to the Switch’s |
|
|
| loses these changes if it is turned off or loses power, so use the Save link on the |
|
|
| top navigation panel to save your changes to the |
|
|
| you are done configuring. |
|
|
|
|
| Cancel |
| Click Cancel to begin configuring this screen afresh. |
|
|
|
|
39.4 DSCP-to-IEEE 802.1p Priority Settings
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default
Table 127 Default
DSCP VALUE | 0 – 7 | 8 – 15 | 16 – 23 | 24 – 31 | 32 – 39 | 40 – 47 | 48 – 55 | 56 – 63 |
|
|
|
|
|
|
|
|
|
IEEE 802.1p | 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
|
|
|
|
|
|
|
|
|
| 357 |
|
|